Name: Precor 5.23
Brand: Precor
Rating: 4 (1 reviews)

To Next Page

To Previous Page

5.23 Ellipitical Fitness Crosstrainer

Page 62

6. Slide the stairarm pivot block onto the crankarm pin and replace the retaining ring removed

in step 5.

7. Slide the stairarm onto the stairarm pivot block. Install and hand tighten the stairarm pivot

block mounting hardware. Torque the stairarm pivot block mounting bolt to 15 ft./lbs.

8. Replace the left and/or right cover sections per Procedure 7.1.

Section One - Things You Should Know2
General Information3
Required Tools and Equipment4
Procedure 2.1 - Accessing the Diagnostic Program5
Procedure 2.2 - Accessing the Information Display7
Procedure 2.3 - Accessing the Set User Parameters Display9
Procedure 2.4 - Documenting Software Problems10
Section Three - Preventive Maintenance11
Every Week11
Procedure 5.1 - Measuring the Resistance of an Eddy Current Magnet13
Procedure 5.2 - Inspecting and Adjusting Belt Alignment and Tension15
Procedure 5.3 - Calibrating the Lift Motor19
Procedure 6.1 - Troubleshooting the Lower and Upper Interconnect Cable21
Procedure 6.2 - Troubleshooting the Keypad and Upper PCA23
Procedure 6.3 - Troubleshooting the Speed Sensor25
Procedure 6.4 - Troubleshooting the Eddy Current System27
Procedure 6.5 - Upper Display Does Not Illuminate29
Procedure 6.6 - Troubleshooting the Lift System32
Procedure 7.1 - Replacing or Removing a Rear Cover Section34
Procedure 7.2 - Replacing a Display Enclosure or Upper PCA36
Keyboard Connector37
Procedure 7.3 - Replacing a Lower PCA38
Procedure 7.4 - Replacing a Lower or Upper Interconnect Cable41
Procedure 7.5 - Replacing a Power Entry Module43
Procedure 7.6 - Replacing a Crankarm Assembly45
Procedure 7.7 - Replacing a Pillow Block Bearing47
Procedure 7.9 - Replacing an Input Pulley Belt52
Procedure 7.10 - Replacing a Step-Up Pulley Belt54
Procedure 7.11 - Replacing a Step-Up Pulley Assembly56
Procedure 7.12 - Replacing a Speed Sensor Assembly57
Procedure 7.13 - Replacing an Eddy Current Magnet Assembly59
Procedure 7.14 - Replacing a Stairarm Pivot Block61
Procedure 7.15 - Replacing a Wheel Assembly63
Procedure 7.16 - Replacing a Stairarm Pedal64
Procedure 7.17 - Replacing a Stairarm65
Procedure 7.18 - Replacing a Ramp Assembly66
Procedure 7.19 - Replacing a Handlebar68
Procedure 7.20 - Replacing a Input Belt Tensioner69
Procedure 7.23 - Replacing a Ramp Mounting Bracket73
Procedure 7.26 - Replacing a Lift Motor79
Procedure 7.27 - Replacing the PROM81
Power Entry Module82
Block Diagram83

Brand	Precor
Model	5.23
Category	Elliptical Trainer
Language	English

Precor 5.23 User Manual

Table of Contents

Other manuals for Precor 5.23

Questions and Answers:

Precor 5.23 Specifications

Related product manuals