5.23 Ellipitical Fitness Crosstrainer
Page 80
9. Depending on the manufacture date of the 5.23, the lower end of the lift motor will either be
fastened with a clevis pin and hitch pin or with a bolt and nut. Unfasten the lower end of the
lift motor and remove the lift motor from the unit.
10. Thread the lift motor yoke onto the replacement lift motor. Insert the retaining bolt, removed
in step 7, into the replacement lift motor and secure it with the retaining nut.
11. Set the replacement lift motor in its mounting position and secure it with the clevis pin and
hitch pin removed in step 9.
12. Reconnect the lift motor connector to its mating connector. Fasten the frame ground
connector to the frame with the screw removed in step 8.
13. Calibrate the lift motor per Procedure 5.3, steps 4-9.
14. Replace both front cover halves.
To Next Page
Loading...
Need help?
General
