page 14
10. Connect the display cable and secure the display console. Diagram 7. As the
display console rests on the upright supports, align the mounting holes. Refer to
Diagram 8, #1. Take the following steps to secure the display cable and console.
a. Attach the cable connector by sliding it into its receptacle underneath the console.
A definite “click” is heard when the cable is properly attached. Refer to Diagram 8,
#2. If you do not hear and feel the connector “snap” into place, reinsert it.
b. So that the cable does not hang below the console, slide it into the two tie
wrap clips found underneath the console. Refer to Diagram 8, #3 and #4.
Diagram 8
Connect the cable.
Display console
1
Diagram 9
Install the
center
handrail.
11. Install the center handrail. Loosen the four fasteners in the center console
bracket with the hex key provided. See Diagram 9, #1. The center handrail is
packaged in two pieces. Install one side at a time by following these steps:
a. Insert a handrail end cap. See Diagram 9, #2.
b. Slide the end of the handrail into the center clamp and rotate the handrail so
that it falls inside the end cap. See Diagram 9, #3.
Cable connector
Upright support
Cable receptacle
Mounting holes
Handrail
clamp
Center
console
bracket
1 2
3
2
3
4
Tie wrap
To Next Page
Loading...
