page 15
Diagram 10
Secure the display
console and center
handrail.
Side bracket screw
(C) with washer (E)
(left side)
Center handrail
mounting bracket
(right side)
c. Align the handrail’s mounting bracket with the holes in the upright support.
Insert two ¾-inch screws (C) with washers (D) and finger tighten. Do not
securely tighten the screws until both sides of the center handrail have been
attached. See Diagram 10, #1.
d. Align the handrail with the side bracket mount. Place a washer (E) on screw
(C) and insert the screw through the handrail and into the side bracket.
Finger tighten. See Diagram 10, #2.
e. Follow steps 9a. through 9d. on the opposite side.
Diagram 11
Secure the the upper
handrail clamp.
Tighten the screws,
but leave room for
adjustments.
Washer (E) with
1½-inch screw (F)
Handrail clamp
12. Install fasteners in the handrail clamp. Diagram 10. Return to the center
handrail clamp and place a large washer (E) onto each of two screws (F). Thread
the screws through the handrail clamp. Finger tighten.
¾-inch screws (C)
with washers (D)
(right side)
To Next Page
Loading...
