COMMERCIAL
PRO
D U C T S
DIVISION
To
access the Club settings, the following must occur:
:l
Check
to
be
sure
that
the
treadmill
is
turned
ON.
D
Check
that
the
Precor
banner
appears
on
the
display.
o
Press
the
appropriate
key
sequences.
(To
cancel entries, press Reset.)
Important
To
access Custom mode, press
Stop
while the Precor banner is displayed.
Within 1/2 second, begin pressing the key sequences. If the system does not detect a
key
press (within 1/2 second) after Stop, it resets to the Precor banner. When you begin
entering a key sequence, each key must be pressed within 4 seconds of the other or
the Precor banner reappears and you have to begin again.
Display
key
functions
within
the
Club
Custom
Mode
....
lets you scroll through the
various selections that appear.
The longer the key is held down,
the faster the numbers scroll past.
Stop advances
to
the next aspect
of
the program without storing the
information that appears
on
the
display.
Change reminds you what part
of
the program you're changing.
Reset
exits Club Custom mode and
displays the Precor banner.
Enter saves the information being
displayed and moves to the
next aspect
of
the program.
Note: The touch sensitive keys can be gently pressed and held to view several
selections. The longer the key is held down, the faster the numbers scroll past.
The display console keys that you need to press to change the language, select
the units
of
measure, set the maximum speed, workout, and pause times, or
change the Custom courses are as follows:
Begin at the Precor banner and press the STOP
key.
Then, within 1/2 second,
initiate the key sequence below.
Speed
T,
Speed
A,
Speed
T,
Reset, Speed
T,
Speed
A,
Speed T
SELECTING
THE
LANGUAGE
Display prompts can appear
in
English, German, Spanish or French. Use the
~6o
keys to
make
your choice and press
Enter
to select it.
Note: The functions of the display console keys while in Club Custom mode are
described in the box above.
DETERMINING
THE
UNITS
OF
MEASURE
Two different units of measure can be selected, Metricor
U.S.
standard. Make your
selection using the
~
• keys. Press
Enter
once the correct unit is displayed.
Note: Anytime you wish to exit the Club Custom mode, press the Reset
key.
The
display attritutes that
you
selected
by
pressing Enterare
saved
and recorded
in
memory.
page
21
To Next Page
Loading...
Need help?
General
