COMMERCIAL
PRO
D U C T S
DIVISION
CHANGING
THE
C956
CUSTOM
COURSES
Note: This aspect of the Club Custom mode does not appear
in
the C954 treadmill.
Two
custom course programs (Course 1 and Course 2) exist
in
the C956 treadmill.
After you modify Course
1 (or opt to bypass it), Course 2 appears on the display.
The keys on the console keypad have a different function than explained
in
the
box
on
page
21.
In
the Custom Course programs, the keys function as follows:
Custom Course Program
Keys
Speed'"
or.
Incline.
or ...
Enter
Stop
or
Reset
moves the blinking LED from column to column.
affects the incline of the selected column.
accepts any changes and stores the course in memory.
exits the course (leaving it unchanged) and resets the
display to the Precor banner.
If you decide to select a custom course, you have the ability to create a new, or
"draw
over"
an existing, course profile. The entire course appears on the display. A
blinking LED appears at the top of the far left column and indicates the starting
position. Any incline changes that you make occur only in that column. The
treadmill's speed is determined
by
the user.
Begin modifying the course profile one cell at a time using any
Incline.
or'"
key.
The available incline range
is
from 1 to 12%.
To
move onto the next column, press
any
Speed ...
or.
key.
(Refer to the chart above.)
When you have finished making changes, press
Enter to save the course profile.
The display moves to the next Custom Course (#2) or returns to the Precor
banner (depending
on
which Custom Course you were modifying).
Note:
To
exit the custom course mode without saving any of the changes, press
Stop
or
Reset. The custom course that existed prior to your changes is re-instated
and the display returns to the Precor banner.
page 23
To Next Page
Loading...
Need help?
General
