COMMERCIAL
PRO
D U C T S
DIVISION
Setting Up the Treadmill
You
do not need any special knowledge or experience to set up the treadmill.
However, because of its size and weight, you will need to obtain assistance.
INSTALLATION
REQUIREMENTS
Follow these installation requirements when installing the treadmill.
If
you
do
not
install the treadmill according to the following guidelines,
you
could
void the Precor
limited warranty.
• Set
up
the treadmill on a solid, flat surface. Unpack and assemble
the
treadmill
close to where you
plan to use
it.
Make sure that the flat surface under the unit is
smooth and
level.
A
level
unit
is
required
for
the user's safety and proper operation.
•
Provide
ample
space
around
the
unit. Open space around the unit makes
for a safer mount and dismount.
• Fill
out
and
mail
the
limited
warranty
card. The serial number can be found
on
the shipping container or
on
the label near the power receptacle. Write the
serial number onto the Precor limited warranty card found
on
the back cover of
this manual and
in
the Obtaining Service section
on
page 7.
• Use
the
appropriate
voltage,
dedicated
circuit,
and
grounding
as
speci-
fied
on
the
treadmill. The treadmill is available
in
both 120-volt and 240-volt
models. Refer to the treadmill's identification label to determine the voltage
that your treadmill requires. Both the 120-volt and 240-volt models require a
dedicated
circuit. A
20
amp circuit is recommended.
CAUTION:
Do
not
use
a
non-grounded
outlet
or
transformer.
Do
not
remove
or
otherwise
bypass
the
plug
with
an adapter. Electrical damage
can
occur
and
void
the
Precor
limited
warranty
if
the
treadmill
is
connected
to
an
improper
power
source. Refer
to
Grounding
Instructions
on
page
2.
ADDITIONAL
TOOLS
NEEDED
Obtain the following tools before assembling the treadmill.
Wire cutter
0 Medium weight string
::J
Bubble level
::J
1/2-inch box end wrench
o SAE standard socket set with a ratchet or 8-inch crescent wrench
ASSEMBLY
INSTRUCTIONS
Take the following steps to assemble the treadmill.
CAUTION:To
avoid
injury
and
ensure
your
safety,
get
assistance
before
moving
the
treadmill
off
the
pallet.
Do
not
drop
the
unit.
1.
Think
about
the site and location. Have your assistants help place the shipping
carton close to the location where
you
plan to use the treadmill. Break down the
side walls of the shipping carton so that they lie flat. Remove the loose contents.
2.
Make
sure
that
the
power
switch
is
OFF. Check the ON/OFF power switch
on the front of the treadmill. Place the switch in the
0 (OFF) position. Make
sure that the treadmill is not plugged into a power source.
page 10
To Next Page
Loading...
Need help?
General
