Product Owner’s Manual: Club Features 9
Choosing a Language
The EFX can display user prompts, text, and user entries in seven
different languages. When the EFX is shipped from the factory, it is
set to display English. To change this setting, perform the following
steps:
1. At the Precor banner, press the following keys in sequence and
without pause:
RESET, QUICKSTART, ENTER, SELECT [7], CROSSRAMP ▲
As shown in Diagram 3, numbers are associated with the
keypad. The numbers 5, 6, 7, 1 appear on the display as you
press the associated key.
Note: No CROSSRAMP keys exist on the EFX534i. Use the
RESISTANCE ▲ key [1] on the left side of the keypad.
SELECT LANGUAGE appears in the display. Use the arrow
keys to choose between ENGLISH, DEUTSCH, ESPANOL,
FRANCAIS, NEDERLANDS, PORTUGUES, and RUCCKIJJ.
Note: Programming prompts are not affected by language
selection. The prompts in this section continue to appear in
English.
2. When you are ready, press ENTER to move to the next program
or press RESET to return to the Precor banner.
Diagram 3: Keypad programming numbers
Selecting a U.S. Standard or Metric Display
The EFX can display measurements in either metric or U.S. standard.
The default factory setting is set to display U.S. standard. To change
this setting, perform the following steps:
3. At the SELECT UNITS prompt, use an arrow key to select a unit
of measure (U.S. STD or METRIC).
4. When you are ready, press ENTER to move to the next program
or press RESET to return to the Precor banner.
EFX524i
EFX534i
1
4
5
3
7
6
8
9
2
1
4
5
3
7
6
8
9
2
To Next Page
Loading...
Need help?
General
