page 33
Keys on the Keypad
The following information explains the different uses of the keys from left to right. To
locate each key, look at the display console or refer to Diagram 26.
CROSSRAMP
▲▼▲▼
▲▼▲▼
▲▼: During a workout, the CROSSRAMP ▲▼ keys let you increase
or decease the ramp’s incline . The display can show a range from 1 to 14. Setting 1
provides the lowest and most level ramp.
When you change the ramp’s incline by pressing the CROSSRAMP ▲ or ▼ key, the
number that appears on the display shows the
target
incline (not necessarily, the
present incline) because the display can change much faster than the ramp level.
Note: Any time during your workout, you can view the actual incline by touching
either CROSSRAMP ▲ or ▼ key. You can opt to change the ramp’s incline, if you
hold the key down for more than one second.
During Setup mode, the CROSSRAMP ▲▼ keys are used for data selection. Pressing
either
▲ ▲
▲ ▲
▲ or
▼▼
▼▼
▼ key does not affect the ramp’s incline. However the ▲ or ▼ keys do
affect what appears on the display. Refer to
Setup Mode and Prompts
on page 30.
RESET: Provides access to diagnostics (see page 35), and lets you exit a course or
the Setup mode prematurely. If you press RESET while in a course, you exit the
course and access the Workout Summary display. Press RESET again to exit
Workout Summary and return to the Precor banner or wait for the ten minute time-
out. Note that if you press RESET during the Setup mode, you also return to the
Precor banner.
QUICKSTART: This key lets you bypass the Setup prompts and start your workout
immediately using the Manual course.
Default values apply.
QUICKSTART Default Values
Prompts Default Value
COURSE Manual
TIME No limit (i.e. NOLIM)
WEIGHT 150 lbs. (68 kg.)
AGE zero: A valid Age must be entered to utilize the SmartRate
®
display. If
QUICKSTART is pressed
after
an AGE is displayed, then the SmartRate
display will appear when you wear the POLAR
®
chest strap. If no “Age”
entry occurs, then SmartRate
is not activated. Note that the Precor Heart
Rate Option is available for purchase through your Precor dealer. Refer
to
Obtaining Service
on page 9.
The QUICKSTART key can be pressed any time during the Setup prompts. For more
information, refer to page 26,
The Setup Mode and the QuickStart Feature
.
SELECT key: During a course, the SELECT key changes what items appear on the
display. To learn about choosing the display items and setting up an automatic scan
of the workout data, refer to
Changing the Display Features Using the SELECT Key.
Diagram 26
EFX
®
5.21i keypad.
Keypad keys
The keys on the keypad let you:
• control your workout session,
• answer prompts prior to starting a course,
• determine which display features appear,
• prematurely end a course, and
• adjust the resistance and crossramp levels.
To Next Page
Loading...
Need help?
Power
Performance
Weight and Dimensions
