page 43
Maintaining the EFX
®
9
CAUTION: Never pour water or spray
liquids on the display console, handrails,
or EFX. Allow the EFX to dry completely
before using.
CAUTION: Turn OFF the EFX and disconnect
the power cord before performing any
maintenance tasks.
The EFX
®
5.21i will continue to run smoothly and efficiently as long as it is maintained
properly. You are responsible for cleaning and maintaining the unit’s integrity. If you fail to
maintain the EFX
®
as described below, it could affect or void the Precor Limited Warranty.
DANGER — To reduce the risk of electrical shock, always unplug the EFX
®
from the its power source before cleaning it or performing any maintenance tasks.
Inspection
Perform a daily inspection of the unit. Look and listen for loose fasteners, unusual
noises, and any other indications that the equipment may be in need of service.
Obtain service should you notice any of the above.
Important: If you determine that the EFX is in need of service, turn OFF the unit and
unplug it. Make sure that the locking pin secures the roller arm.
To order parts or to contact a Precor authorized service provider in your area, refer to
Obtaining Service
on page 9.
Cleaning the Equipment
Most of the working mechanisms are protected inside the casing. However, for
efficient operation, the EFX relies on low friction. To keep the friction low, the EFX
wheels, ramp, and internal mechanisms must be as clean as possible.
Everyday use a soft cloth, dampened (not dripping wet) in a diluted solution of mild
soap and water and clean all exposed surfaces on the EFX.
To clean the ramp and roller wheels:
1. Check to make sure that the EFX is turned OFF.
2. Remove the locking pin. Refer to page 23.
3. Position one foot pedal at the top of the ramp (the other will automatically be
positioned at the bottom).
4. Clean the exposed ramp and roller wheel surfaces.
5. Switch the foot pedal positions to finish cleaning the ramp.
6. Gently, lift the roller wheel and rotate it while you wipe it. This helps removes any
dust or dirt which might affect the smooth operation of the unit.
Periodically, clean the grooves on the foot pedals using a soft nylon scrub brush. Vacuum
the floor underneath the unit every week to prevent the accumulation of dust and dirt.
Servicing the EFX
Do not attempt to service the EFX
yourself except for the maintenance tasks described in
this manual. The unit does not contain any user-serviceable parts that require lubrication.
For information about product operation or service, call 1-800-347-4404.
Long Term Storage
When the EFX is not in use for any length of time, turn it OFF. Ensure that the power
cord is unplugged from the wall outlet and is positioned so that it will not become
damaged or interfere with other equipment or people.
To Next Page
Loading...
Need help?
Power
Performance
Weight and Dimensions
