E-Stop Not Communicating
The error 37 is generated by the upper PCA
1
in the console when the lower control module
gets into an E-Stop state and the upper PCA in the console did not know about it. The system
uses pin 8 of the data cable to communicate E-Stop states between the console and the lower
control module.
Related Error Codes
E-Stop error code: 37.
Refer to the Error Code Troubleshooting Guide for error code description and troubleshooting
information.
Procedure
Refer to the Error Code Troubleshooting Guide for error code description and troubleshooting
information.
See Also
"System Troubleshooting Procedures" on page 99
1
Printed circuit assembly, generally referred to as either an upper PCA or lower PCA.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 111
7 Troubleshooting
System Troubleshooting Procedures
To Next Page
Loading...
Need help?
General
