SYSTEM SETTINGS
MENU
DESCRIPTION
REGISTER
EQUIPMENT
Used to register the P80 after Connectivity interface has been con-
figured and established.
MANAGE SETTINGS Used to save your equipment settings to a USB flash drive, or to
import settings from a USB flash drive.
Note:* not available on all models.
Information Display (65)
Service Access Code: 6, 5 (see "Service Access Codes" on page10)
Information Display provides information about the equipment usage, hardware, software,
and error log data. . Select console model to view the available information and data.
Standard, P10, P20, & P30 consoles:
METRIC DESCRIPTION
ODOMETER Displays the total number of accumulated miles on the unit.
This value is stored in the upper PCA in the console so if
the PCA is replaced the accumulated miles would start
again from "0".
HOUR METER Displays the total number of hours that the unit took to
accumulate unit miles.
This value is stored in the upper PCA in the console so if
that PCA is replaced the hours of use would start again
from "0".
BELT RATING Displays a belt rating from 10 (best) to 0 (worst). Reset-
table to 10 by holding QuickStart.
U-BOOT SW Displays the software part number and current version
installed in the upper PCA (console). This is the unit spe-
cific console software.
LOWER SW Displays the current version of software loaded in the
Machine Controller.
METRICS BOARD SW Displays the current version of software loaded in the met-
rics board.
SER NUMBER Displays the model and serial number of the equipment.
The base serial number can be set here using the
WinCSAFE computer software. The factory default is
NONE.
USAGE LOG Displays the type of workout programs the users are
accessing most frequently.
"Error Log" on page73 • Displays the number of times each workout has been
used and displays the associated cumulative minutes.
• Displays the user preferences in workout selection.
(Undefined variable: TRM700-16Base.ServiceManualTitle)
18
3 Standard Service Software
Information Display (65)
To Next Page
Loading...
