Precor GEN06 Series C952 - Club Parameter - Settings (5651565)

DIAGNOSTIC
TEST
TEST DESCRIPTION
Numeric Backlight
Test
Tests the backlight level on the speed and incline parameter displays.
Numeric Display
Test
Tests the speed and incline numeric indicators.
Heart Rate Test Tests the Hands ON/OFF Status, Raw and Filtered pulse values. Grasp the
touch grips to test the hand held heart rate. Use a Polar heart rate simulator to
test the wireless heart rate.
Club Parameter - Settings (5651565)
Service Access Code: 5, 6, 5, 1, 5, 6, 5 (see "Service Access Codes" on page10)
Club Parameters or Club Settings are used to manage and configure the usage of the
machine. Select a console model to view the available club parameters.
Standard, P10, P20, & P30 consoles:
CLUB PARAMETER DESCRIPTION
SAFETY CODE
(Treadmill only)
Range: Enable/Disable
Default:Disabled
Enable or disable* the Safety Code. When enabled, the setting
requires a password "1234" to be entered to start the unit.
SELECT LANGUAGE
Default:English
Sets the default language for all workouts on this machine. Lan-
guage for single use workouts can still be set by the user from the
workout options.
SET UNITS Range: U.S, Metric
Default: U.S.
Sets units of measure to US standard* or Metric.
SET MAX WORKOUT
TIME
Range: 1 to 240 min, NO LIMIT
Default: 60 min
Sets the maximum allowable user workout time per session.
SET MAX PAUSE
TIME
Range: 1 to 120 sec
Default: 120 sec
Sets how long the equipment remains in a paused banner during a
workout before resetting.
SET COOL DOWN
TIME
Range:1 to 5 min
Default: 5 min
Sets the amount of time that a cool down period will occur at the
end of every workout. Factory default is 5 minutes. Settable in 1
minute increments.
(Undefined variable: TRM700-16Base.ServiceManualTitle)
15
3 Standard Service Software
Club Parameter - Settings (5651565)