Precor GEN06 Series C952 - E-Stop Not Communicating

E-Stop Not Communicating
The error 37 is generated by the upper PCA in the console when the lower control module
gets into an E-Stop state and the upper PCA in the console did not know about it. The system
uses pin 8 of the data cable to communicate E-Stop states between the console and the lower
control module.
Related Error Codes
E-Stop error code: 37.
Refer to the Error Code Troubleshooting Guide for error code description and troubleshooting
information.
Procedure
Refer to the Error Code Troubleshooting Guide for error code description and troubleshooting
information.
See Also
"System Troubleshooting Procedures" on page74
(Undefined variable: TRM700-16Base.ServiceManualTitle)
86
6Troubleshooting