6. Re-Install the actuator tube into the incline platform mounting bracket. It may be neces-
sary to slightly rotate the actuator tube to align the clevis pin mounting holes. Choose
the adjustment direction that will minimize the change to the actuator tube reference dis-
tance. Hold the jack screw from turning while adjusting the actuator tube.
7. Return the treadmill to the upright position or remove support blocks.
8. Level the Treadmill.
9. Install the hood.
10. Connect the power cord and set the treadmill circuit breaker to ON.
11. Verify the treadmill incline operation through the full range of motion. Do the "Hardware
Validation - Diagnostic Tests (51765761)" on page13 - INCLINE TEST diagnostic test.
12. Verify treadmill operation (see "Operation Verification" on page8) and return to service.
.See Also
"Replacement Procedures" on page29
"Incline Lift Motor Replacement" on page48
(Undefined variable: TRM700-16Base.ServiceManualTitle)
25
4 Adjustment Procedures
Lift Motor Calibration
To Next Page
Loading...
