Precor GEN06 Series C952

To Next Page

To Previous Page

8. Install the actuator tube into the incline platform mounting bracket. Hold the jack screw

from turning while inserting the actuator tube into the mounting bracket. Secure with

clevis and hitch pins.

9. If the Lift Motor actuator tube has turned during the installation process (which changes

the incline reference gap distance) re-calibrate the Lift Motor, see "Lift Motor Cal-

ibration" on page24.

10. Return the treadmill to the upright position.

11. Level the treadmill.

12. Install hood and all removed covers and trim.

13. Connect the power cord and Switch the input power to ON.

14. Verify the treadmill incline operation through the full range of motion. Do the "Hardware

Validation - Diagnostic Tests (51765761)" on page13 - INCLINE TEST diagnostic test.

15. Verify treadmill operation (see "Operation Verification" on page8) and return to service.

Precor GEN06 Series C952 - Page 58