Precor GEN06 Series C952 - Page 66

5. Remove the fasteners that retain the AC power cord clamp and remove the clamp.
Keep fasteners for replacement installation.
6. Disconnect the AC power cord from the input module.
7. Feed the end of the replacement AC power cord that mates with the input module
through its hole in the frame and firmly insert it into the input module.
8. Set the AC power cord clamp in its mounting position and install using the previously
removed fasteners.
9. Set the AC input panel in its mounting position and install using the previously removed
fasteners.
10. Plug in the power cord and Switch the input power ON.
11. Verify treadmill operation per ""Operation Verification Procedure" on page8" and return
to service.
.See Also
"Replacement Procedures" on page29
(Undefined variable: TRM700-16Base.ServiceManualTitle)
60
5 Replacement Procedures
Power Cord Replacement