Precor GEN06 Series C952 - Page 69

19. Check the alignment of the magnet and the auto stop assembly, see "Auto Stop Sensor
Replacement" on page32.
20. Tighten and torque the Deck mounting bolts to 150 in-lbs (17 N-m).
21. Reinstall the Drive Roller and Drive Belt, see "Drive Roller Replacement" on page42.
22. Reinstall the Take Up Roller, see "Take Up Roller Replacement" on page66.
23. Tension and verify the running belt tracking, see "Running Belt Tension and Tracking
Adjustment" on page26.
24. Replace the belt guard cover ensuring the tabs are firmly locked into position on the
Take Up Roller shaft, see "End Cap & Belt Guard Cover Replacement" on page46.
25. Replace the end cap, see "End Cap & Belt Guard Cover Replacement" on page46.
New Deck break-in
26. Straddle the running belt and set the speed to 3 mph (5 kph). While holding the treadmill
handles, walk onto the middle of the running belt starting from the back walking to the
front and returning to the back. Repeat walking process 4 times.
(Undefined variable: TRM700-16Base.ServiceManualTitle)
63
5 Replacement Procedures
Running Belt and Deck Replacement