Introduction
If you are not a Precor certified servicer, you must not attempt to service any Precor Product.
Call your dealer for service information.
WARNING: This service documentation is for use by Precor certified servicer providers
only. Personal injury can result from electrical shock and/or mechanical moving parts.
This service manual applies to the following treadmill models:
l GEN06 series treadmill (120 VAC
1
and 240 VAC models): The GEN-06 treadmill base
is defined as any treadmill produced between April 2006 and April 2011. GEN-06 Tread-
mills include the following models; C952, C954, C956, and C966.
l TRM10
2
series treadmill (120 VAC and 240 VAC models): The TRM10 treadmill base
is defined as any treadmill produced after April 2011 and is configured with a Pxx series
console. All of the base and console combinations are part of the "Experience" line of
products.
This document contains information required to perform troubleshooting and replacement pro-
cedures required to repair and maintain this equipment including: general product information,
software diagnostic procedures, preventative maintenance procedures, inspection and adjust-
ment procedures, troubleshooting procedures, replacement procedures and system block and
wiring diagrams.
Separate Base and Console Service Manuals
This document provides information to service the equipment base independent of the
installed console. For console service documentation, refer to the particular console service
manual.
Additional Documentation
1
voltage in an alternating current circuit
2
TRM800 version 1 treadmills mfg. dates 2010 thru 2014.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 1
1 Introduction
To Next Page
Loading...
Need help?
General
