Power Cord Replacement
About
This procedure provides instruction to remove and replace the power cord.
CAUTION: Use only Precor OEM power cords. Do not remove or otherwise bypass
the 3-prong plug with an adapter to use a non-grounded outlet. Do not plug the unit
into a power transformer in an attempt to adjust the voltage requirements. Failure to
follow these instructions might damage the unit and void the Precor Limited War-
ranty.
CAUTION: The treadmill requires a 20-amp individual branch circuit grounded per
NEC (National Electric Code) guidelines or local region electric code.
Procedure
Review entire procedure before starting.
1. Set the treadmill circuit breaker to OFF and unplug
1
the treadmill’s power cord from the
AC
2
outlet.
2. Remove the treadmill’s hood.
3. Remove the two screws that fasten the AC input panel to the frame. Keep fasteners for
replacement installation.
4. Lift the AC input panel from the frame and rotate it to expose the AC power cord clamp
screws.
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
2
Alternating Current: electric current which periodically reverses direction between positive
and negative polarity.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 79
6 Replacement Procedures
Power Cord Replacement
To Next Page
Loading...
Need help?
General
