S3.25 Leg Press Option Assembly Instructions
page 6
1 2 3 4 5 6
3
Assembly
Instructions
Assembly Instructions
Assembly of the Leg Press Option takes professional
installers about 1 hour to complete. If this is the first time
you have assembled this type of equipment, plan on
significantly more time.
Professional installers are highly recommended!
CAUTION: Obtain assistance! Do not attempt
to assemble the Leg Press Option by yourself.
Because of the weight and size of the Leg Press
Option, you could be injured or damage the
equipment. Review the Installation Requirements
on page 5 before proceeding.
The Leg Press Option comes in one box. It can be
installed on either the S3.25 or S3.45 Precor Strength
Training Equipment. Note that the location where you
attach the Cross Brace to the Seat Frame differs.
As you read through the assembly instructions, be
sure that you are using the correct mounting holes for
your unit.
Be careful to assemble the components in the
sequence presented in this guide.
Note: As with any assembled part, proper alignment and
adjustment is critical. While tightening the fasteners, be
sure to leave room for adjustments. Do not fully tighten the
fasteners until instructed to do so.
To Next Page
Loading...
Need help?
Weight and Dimensions
