132020 Voxx Electronics Corporation. All rights reserved.
5 Button Remote Control - Model 185SP
The CR2032 battery inside each remote control should last approximately 1
year under normal use. When the batteries become weak you will notice the
remote control range (the distance from the vehicle the remote control will
work) deteriorate and the small LED on the remote control will dim. To replace
the remote control batteries:
1. Using a coin, disassemble the halves of the remote control.
2. Remove the old battery, observing the +/- symbols on the batteries
and replace with a new battery.
3. Reassemble the halves of the remote control.
4. Test operation of the remote control.
1. Cycle the vehicle ignition ON.
2. Press and release the valet button three (3) times.
3. Press the
button of each remote control you wish to program, the
parking lights will ash to conrm each remote control has beep
programmed
4. Turn the vehicle ignition OFF.
NOTE: This system has one (1) button programming which programs all
channels of the system.
NOTE: The system will hold up to four (4) remote controls in memory,
programming a 5th remote control will erase the oldest remote control in
memory.
Programming Your Remote Control
Replacing The Batteries
To Next Page
Loading...
