52020 Voxx Electronics Corporation. All rights reserved.
Valet Mode
When valet mode is activated the status LED will light solid, and all security
will be disabled. To enter or exit valet mode simply follow the steps outlined
below:
1. Turn the vehicle’s ignition ON.
2. Push and hold the valet button.
3. The LED will turn on solid when valet mode is active.
4. Release the valet button.
Manually Overriding the Security System
Your system can be disarmed without the use of the remote control. This is
necessary to operate your vehicle if the remote control is lost or its battery
fails. To by-pass the alarm system;
1. Open the vehicle door. The alarm will sound.
2. Turn the ignition key to the ON position.
3. Within ten (10) seconds, press and release the valet button.
The alarm system will stop sounding and enter the (by-passed) mode. You
can now start and operate the vehicle normally.
Stand Alone Valet Override (Optional)
Your system can be disarmed without the use of the remote control or valet
button. This is necessary, since you will need the ability to operate your
vehicle if the remote control is lost or its battery fails. To by-pass the alarm
system;
1. Open the vehicle door. The alarm will sound.
2. Cycle the ignition key ON, OFF, ON.
3. Within ten (10) seconds, press and release the Brake pedal three
(3) times.
The alarm system will stop sounding and enter the (by-passed) mode.
You can now start and operate the vehicle normally. This feature must be
programmed ON by an authorized dealer.
To Next Page
Loading...
