92020 Voxx Electronics Corporation. All rights reserved.
Using the “Quick-stop” Feature (Optional)
If you want to make a short stop and keep your vehicle running (to keep
the interior warm or cool), the quick-stop feature allows you to do this while
keeping your vehicle secure and your keys with you.
To engage Quick Stop:
1. Stop the vehicle and place the transmission in PARK.
2. With your foot o the brake pedal, press and release the
button
two (2) times within 2 seconds. The parking lights will turn ON to
conrm quick stop is entered.
3. Remove the keys from the ignition and exit the vehicle. Press the
button to lock the vehicle’s doors if desired.
To engage Quick Stop - Manual Transmission Vehicles:
1. With the vehicle running, foot o the brake, parking brake set ON.
2. Press and release the
button to activate remote start.
3. Exit the vehicle close all doors (Door Open/All Doors Close)
4. Press and release the
button.
5. Within 3 seconds press the
button:
The unit enters Quick Stop Mode and will remain running until remote start
time-out and then shuts down. (Remote Start Ready Mode is now active)
Note: Do not leave children or animals unattended in the vehicle when
using the quick-stop feature.
Cancelling Remote Start Ready Mode - Manual Transmission Vehicles
Only
The system will exit remote start ready mode if any of the following occur:
• Open any door.
• Open the hood or trunk (if connected).
• Press the brake.
• Release the parking brake.
• Turn the ignition ON.
To Next Page
Loading...
