Prestige APS787Z - Page 6

6 APS787Z Owners REV.B
Custom Code Valet Override (Optional)
Unlike the default Valet Override, Custom Code Override is a user
personalized code that o󰀨ers a higher level of security. If the user chooses to
use Custom Code Override, Feature Bank 2 ; Feature 9 must be programmed
for “Custom Code”. Once the option has been selected the code must be
programmed. Once the Custom Code is programmed it cannot be changed
without rst disarming the alarm.
Custom Code Override Procedure
The Custom Code is made up of 2 numbers. Each chosen number must be
between digits 1-9. The default Custom Code is “11”. To disarm the alarm
using the Custom Code option:
1. Turn the vehicle ignition to ON.
2. Within ve (5) seconds, Press the valet button one (1) time.
3. Within ve (5) seconds, Turn the ignition OFF/ON.
4. Within ve (5) seconds, Press the valet button one (1) time.
5. Turn the vehicle ignition to OFF then ON to start the vehicle.
Custom Code Programming Procedure
In this example, the user has selected Custom Code “23”. To program a user
selected custom code:
Start with the alarm disarmed.
1. Turn the ignition to the ON position.
2. Within ten (10) seconds, press the valet button three (3) times to
enter programming.
3. Within ten (10) seconds, Cycle the ignition OFF/ON, OFF/ON, OFF/
ON. The system will beep one (1) time.
4. Within ten (10) seconds, Press the valet button two (2) times. This
number will indicate the rst digit of the chosen Custom Code.
5. Within ten (10) seconds, Cycle the ignition OFF/ON.
6. Within ten (10) seconds, Press the valet button three (3) times. This
number will indicate the second digit of the chosen Custom Code.
7. Cycle the ignition OFF.
If the Custom Code was accepted the LED will ash the rst number (2),
pause, then the second number (3). This will repeat two (2) more times to
conrm the Custom Code entry. If after fteen (15) seconds the LED does not
ash please repeat steps 1-7.