Components Identification 4
First use: how to choose the correct power source 5
First use: switch on and activation of wireless network 6
First use: Setting remote control with iPhone or iPad 10
First use: Setting remote control from a Windows computer 14
First use: Setting remote control from a Mac computer 16
First use: Setting remote control from an Android device 20
First use: backup your SSD drive before installing your software 24
First use: install your software 29
First use: turn off EAGLE 30
First use: installing EAGLE on the telescope 31
First use: powering other instruments connected to the EAGLE 34
First use: remotely control devices with EAGLE Manager 36
- connect or disconnect every power out port of EAGLE 38
- set power out voltage of the 3 power out ports with adjustable voltage 39
- connect or disconnect devices attached to the 4 USB 2.0 ports 40
- check for power in voltage and battery lifetime 40
- set WiFi connectivity 41
-
remotely turn on/off the entire telescope 43
- change the password of the WiFi network created by EAGLE 44
- Check for GPS data 45
- EYE sensor data 47
- DARK mode 48
Advanced use: EAGLE ASCOM drivers 49
Advanced use: program connection and power to devices 50
To Next Page
Loading...