540876_A_PUB_DATE_1_FEB_2012.DOC PROGRAMOVACÍ MANUÁL 23
SETUP
(*) Automatic Cooldown
To avoid mechanical temperature shock and to extend the life time of your washing machine, after a hot
wash, cold water is injected bit by bit. As a result at the end of the hot wash, the temperature will be
lowered to about 65°C.
The automatic cooldown function will only be functional if a hot wash with a temperature above 65°C has
been programmed and if a cold water inlet valve is programmed in the next step. When a Cooldown
sequence has been programmed, the automatic cooldown will not function.
The automatic cooldown differs from a normal cooldown sequence. The purpose of a normal cooldown
sequence is to avoid the shrinking of the garments. (Takes more time)
See Chapter 5.
To Next Page
Loading...