22 PROGRAMOVACÍ MANUÁL 540876_A_PUB_DATE_1_FEB_2012.DOC
Menu Item Default Info Limits
Max. Water Fill Time 10 Min A diagnostic message is generated by the wash
computer when the water hasn't reached the
programmed level in 10 Minutes. (Err 11)
Attention!
If 99 minutes has been selected, NO error message will be
generated at all, even if the heating time exceeds 99 minutes.
The machine will only stop filling when the programmed
water level has been reached.
5 - 99 Min
Overfill Detection 10 units A diagnostic message is generated by the wash
computer when the water has reached the
programmed level + 10 units. (Err 12)
Attention!
It's strongly recommended that the heating power of the
steam installation has enough power to heat the bath
quickly. Otherwise the tub will be filled with extra water and
an error message will occur that the machine takes more
then 10 units extra water. This will also increase the water,
energy and detergent supply consumption.
To solve the problem in another way, reduce the
programmed target water level so that less
energy is needed to heat up the bath and with the
extra water of the condensed steam you will wash
with a normal amount of water.
10 - 25 units
External Wait Control Off
Liquid soap supply system:
Slection for a washing machine connected to a central
liquid soap supply system.
Some washing machines are connected to a central
liquid soap supply system which can only provide 1
washing machine at a time with liquid soap.
This central pump system is able to let Wait the washing
machine before continuing the wash process until the
central pump system is free to pump the liquid soap
supply into the machine.
Heating, (for installations with limited power supply):
You can disable the heating system of the machine
by an external signal.
The heating will switch on again and the wash process
will continue as soon as the external signal is switched off.
Wait:
External signal suspends the whole wash process until
the external signal gets switched off.
Off / Soap /
Heating / Wait
Prewash Soap Info Yes
Selection whether the information on soap dosage for
prewash should be shown or not.
No / Yes
Wash Liq. Soap Info Yes
Selection whether the information on liquid soap
dosage for the main wash should be shown or not.
No / Yes
Exit
Return to Main Menu
!
!
To Next Page
Loading...