540876_A_PUB_DATE_1_FEB_2012.DOC PROGRAMOVACÍ MANUÁL 21
SETUP
Menu Item Default Info Limits
Temperature Balance No The right water temperature at the water fill process is
obtained by switching the cold and hot water inlet
valves. For high temperatures extra heating will be
required after the fill process. For some special
customer applications, it is allowed to switch off the
automatic Temperature Balance control.
No / Yes
Motor On Time 12 Sec At normal wash action, drum turns for 12 seconds.
Recommended 3 Sec for Gentle wash action.
(= suggested values for the program menu)
1 - 99 Sec
Motor Off Time 3 Sec At normal wash action, drum is stopped for 3 seconds.
Recommended 12 Sec for Gentle wash action.
(= suggested values for the program menu)
1 - 99 Sec
Smart Motion Yes
This option decreases the drum R.P.M. during water
filling therefore the laundry absorps water more quickly
and washing efficiency increases.
No / Yes
Hot Water Heater Temp. 60 °C The Hot Water Heater Temperature should correspond
with the hot water supply of the washing machine.
The value of the hot water supply temperature is
required to obtain a correct bath temperature at the
water fill process.
50 - 80 °C
Temp. Overshoot Prot. 00 % To avoid temperature overshoot at steam heating,
the % value is the reduced temperature at which the
heating is switching off before reaching the target
value. In the tub cold and hot water gets mixed and if
after 30 seconds the programmed target temperature
is not reached, the heating will be started again.
0 - 30 %
Max. Heating Time 60 Min A diagnostic message is generated by the wash
computer when the water hasn't reached the
programmed temperature in 60 Minutes. (Err 14)
Attention!
If 99 minutes has been selected, NO error message will be
generated at all, even if the heating time exceeds 99 minutes.
The machine will only stop heating when the programmed
temperature has been reached.
10 - 90 Min
!
To Next Page
Loading...