42 PROGRAMOVACÍ MANUÁL 540876_A_PUB_DATE_1_FEB_2012.DOC
THE COOLDOWN SEQUENCE
After a Hot wash you can program a Cool-down Sequence to avoid temperature shock and
shrinking of the garments.
The drain step after the Hot wash must be put on NO DRAIN.
No inlets are programmable :
- machine with three water inlets: inlet 7 is the standard inlet.
- machine with two water inlets: inlet 1 is the standard inlet.
The water level can‘t be programmed as the process of adding and draining water doesn’t allow this.
ATTENTION!
DO NOT PROGRAM A DRAIN SEQUENCE BEFORE A COOLDOWN SEQUENCE
Menu Item Default Info Limits
Temperature 60 °C The water temperature.
1 - 60 °C
RPM - The suggested RPM depends on the machine Type. See table 3.5.B
Drain Valve 1 Only available on washing machines with both : a
normal Open and normal Closed Drain valve.
1 - 2
On Time 12 sec The wash action, motor On Time.
Gentle wash action : 3 sec.
(The suggested default values can be adjusted at the Initialization menu)
1 - 99 sec
Off Time 3 sec The wash action, motor Off Time.
Gentle wash action : 12 sec.
(The suggested default values can be adjusted at the Initialization menu)
1 - 99 sec
Time 7.0 Min The programmed time = time needed to decrease the
water temperature.
Once the programmed temperature has been reached,
the next Sequence will be started.
(for 0 Minutes the Cooldown sequence will be skipped)
(programmable in steps of 0,5 Minutes)
Attention!
If a short time is programmed, the water temperature will
decrease fast.
Recommendation!
Program 1 minute for each 3°C temperature drop.
Example :
For a hot wash of 90°C and a Cooldown Sequence of 60°C a
time of about 30°C/3°C = 10 Minutes should be programmed
for the Cooldown Sequence.
0 - 99.5 Min
Signal No When a signal is programmed, a pause will be
introduced at the end of the Wash Step. This allows
the operator to add soap for the next step. A buzzer
signal warns the operator that the cycle has been
interrupted.
No / Yes
Prewash
Wash
Cooldown
Rinse
Final Rinse
Soak
S
ra
No wash
!
!
To Next Page
Loading...