Prins VSI - Electrical Connections; Power, Ground, and Sensor Wiring

PAGE 19
076/19060100
Copyright © Prins Autogassystemen B.V. 2011
Renault
Clio 1.2 16v TCe100 2011
VERSION NR : C
19
Electrical connections
Check and measure the wiring in case of changes in the cars wiring colours.
Insulate all not used wires. Alle wires are connected to the GREY petrol ecu connector.
Wire number / code
Wire colour
Connection
1 ground battery
brown
Connect to the ‘–‘ of the battery; use a ring terminal for this
purpose.
32 ground battery sense
brown
Connect to the ‘–‘ of the battery together with VSI wire 1
ground battery.
44 +12V battery
red
Connect to the '+' of the battery; use a ring terminal for this
purpose or solder.
Do not place the fuse in the holder before having completed
the installation of the LPG system.
13 +12V battery sense
red
Connect to the ‘+‘ of the battery together with VSI wire 44
+12V battery.
112 + petrol injectors
red-grey
Make a connection to + petrol injector.
Wire colour : red
Wire location : pos G1
20 AD3 ( lambda 1 )
orange
For the measurement of the lambda signal of cylinder bank 1
Connect the wire in parallel to the lambda sensor.
Wire colour : white - black
Wire location : pos C3
19 AD4 ( lambda 2 )
orange-white
For the measurement of the lambda signal of cylinder bank 2
Connect the wire in parallel to the lambda sensor.
Wire colour : not connected
Wire location :
18 AD1 ( MAP )
blue
For measuring the inlet manifold pressure ( MAP ).
Wire colour : green - black
Wire location : pos A3
17 AD2 ( Valve Care )
Green
White-yellow
Brown
Green-yellow
Red
VSI ecu connector: Pos AD2 (green)
VSI ecu connector: Pos 121 (yellow white)
VSI ecu connector: Pos 1 (brown)
VSI ecu connector: Pos 24 (green-yellow)
VSI ecu connector: Pos 112 (red)
8 RPM
purple-white
For measuring the engine speed.
Wire colour : brown
Wire location : pos G4