Prodigit 3310F Series - Page 26

3310F Series Operation Manual 19
• If CC mode is selected the lower display provides setting in amps "A".
• If CR mode is selected the lower display provides setting in ohms “Ω”
• If CV mode is selected the lower display provides setting in volts “V”.
• If CP mode is selected the lower display provides setting in watts “W”.
3.2.7.2. LIMIT. Each press of the LIMIT button changes the middle LCD text. The
Sequence and the corresponding setting value shown on the bottom
Display are as follows:
 V_Hi (upper limit voltage) displays the set value in volts “V”
 V_Lo (lower limit voltage) displays the set value in volts “V”
 I_Hi (upper limit current) displays the set value in amps “A”
 I_Lo (lower limit current) displays the set value in amps “A”
 W_Hi (upper limit power) displays the set value in watts “A”
 W_Lo (lower limit power) displays the set value in watts “A”
 NG displays whether the NG flag is set to「ON」or「OFF」
3.2.7.3. DYN setting. Each press of the DYN setting button changes the text on
The middle LCD. The sequence and the corresponding setting value
Shown on the bottom display are as follows:
 T-Hi (time high) displays the set value in milliseconds “ms”
 T-Lo (time low) displays the set value in milliseconds “ms”
 Rise (current rise time/slew rate) displays the set value in “A/us” or
“A/ms”
 Fall (current fall time/slew rate) displays the set value in “A/us” or “A/ms”
3.2.7.4. CONFIG. Each press of the CONFIG button changes the middle LCD
Text.
The sequence and the corresponding setting value shown on the bottom
Display are as follows:
 SENSE can be set to「AUTO」or 「ON」
 LDon (load ON voltage) displays the set value in volts “V”
 LDoff (load OFF voltage) displays the set value in volts “V”
 POLAR (load polarity) can be set to「＋LOAD」or「－LOAD」
 MPPT (load maximum power point tracking) can be set CC/CR/CV mode.
 AVG (load Measuring V.I Average)can be set 1 to 64.
3.2.7.5. SHORT test. This allows the parameters of the short test to be set up.
Each press of the SHORT button moves the setting function. The
Sequence of the short test along with the setting value is as follows:
 Short Press Start (pressing the red START/STOP button starts the test)
 TIME shows the duration of the SHORT test. “CONTI”, on the bottom
display indicates continuous. Time can be adjusted in “ms”.
 V-Hi (voltage high threshold) displays the set value in volts “V”
 V-Lo (voltage low threshold) displays the set value in volts “V”
When the test is started the lower display will show RUN. When the test
Has finished the lower display will show END.