Prodigit 3310F Series - Page 53

46 PRODIGIT
3.2.25. The withdraw handle
The following procedure details how to remove the 3310F series Load Module from
the mainframe.
 Firstly ensure that the mains power to the 3300F/3302F/3305F mainframe is
Switched off. Failure to do so may result in damage to the load module.
 Take the screw out of the withdraw handle in the lower right corner of the
Module.
 After removal of the screw the handle can be pulled towards you to lever the
Module out of the mainframe.
The picture below illustrates the handle operation in the 3300F. The procedure is
the same for the 3302F and 3305F mainframes.