93-346-80 Issue 4 © Copyright Protec Fire Detection PLC 2011
Making a Call to an Outstation
Pick up the handset, the Dial Tone can be heard.
Select the Outstation to be called by pressing the relevant button.
The LCD will change to Calling, the ringing Tone can be heard and selected LED will flash Red.
Connection is established when the Outstation handset is picked up or the Call / Answer button is
pressed.
The Outstation Indicator LED will go steady.
Terminating a Call
Calls are terminated by replacing the handset at the MCU.
If the handset at a Fire Telephone outstation has not been replaced, the Outstation indicator LED will
continue to flash, and can be reconnected by pressing the relevant Outstation button.
NOTE – Factory Default software settings has buttons 33 – 36 allocated as panel
handsets. Therefore button 33 is allocated as handset on panel 1 and flashes
when the handset is lifted or called. As will 34 – 36 on their respective panels.
CALL CALLING
WAITING: REFUGE POINT XX
LOCATION: SITE RELATED TEXT 1 CALL
TIME: TIME / DATE
ENTER/FN: SCROLL
To Next Page
Loading...