Prusa Research MINI+ User Manual (English)

To Next Page

Table of Contents

Manual changelog MINI+ semi-assembly 3 ................................................................

Step 1 - Version history 4 .................................................................................................

Building your MINI+ 5 ...........................................................................................................

Step 1 - Preassembled vs kit version 6 ...........................................................................

Step 2 - Different hardware revisions 6 .........................................................................

Step 3 - All the required tools are included 6 ...............................................................

Step 4 - Use labels for reference 7 .................................................................................

Step 5 - We are here for you! 7 ........................................................................................

Step 6 - XYZ-axes parts preparation 8 ..........................................................................

Step 7 - XYZ-axes parts preparation 8 ...........................................................................

Step 8 - Foam pads - preparation 9 ...............................................................................

Step 9 - Foam pads installation 9 ...................................................................................

Step 10 - Opening the box with the electronics 10 ......................................................

Step 11 - Connecting the LCD cable 10 ..........................................................................

Step 12 - Connecting the Y and XZ-axis assembly 11 .................................................

Step 13 - Joining the parts together - preparation 12 ..................................................

Step 14 - Protecting the LCD cable 13 ...........................................................................

Step 15 - Joining the parts together - phase 1 13 ..........................................................

Step 16 - Joining the parts together - phase 2 14 .........................................................

Step 17 - Joining the parts together - phase 3 14 .........................................................

Step 18 - Aligning the XZ-axis assembly 15 ..................................................................

Step 19 - Final tightening 15 ............................................................................................

Step 20 - Haribo time! 16 .................................................................................................

Step 21 - LCD parts preparation 16 ................................................................................

Step 22 - Mounting the LCD 17 .......................................................................................

Step 23 - Connecting the LCD 17 ...................................................................................

Step 24 - Guiding the LCD cable 18 ...............................................................................

Step 25 - Connecting the Y-axis motor 18 ....................................................................

Step 26 - Connecting the heatbed cable 18 ..................................................................

Step 27 - Filament sensor (optional) 19 .........................................................................

Step 28 - Filament sensor installation (optional) 19 ....................................................

Step 29 - Connecting the filament sensor (optional) 20 ............................................

Step 30 - Covering the electronics 20 ...........................................................................

Step 31 - Haribo time! 21 ..................................................................................................

Step 32 - Spool holder parts preparation 21 .................................................................

Step 33 - Spool holder parts preparation 22 ................................................................

Step 34 - Assembling the spool holder base(s) 22 ......................................................

Step 35 - Adding the spool holder rails 23 ....................................................................

Step 36 - Adjusting the spool holder width 23 ............................................................

Step 37 - Attaching anti-slip pads 24 ............................................................................

Step 38 - Haribo time! 24 .................................................................................................

Step 39 - Finalising the assembly 25 .............................................................................

Step 40 - Connecting the PSU 25 ..................................................................................

Step 41 - What is next? 26 ...............................................................................................

Need help?

Do you have a question about the Prusa Research MINI+ and is the answer not in the manual?

Prusa Research MINI+ Specifications

General

Build Volume	180 x 180 x 180 mm
Layer Height	0.05 - 0.35 mm
Nozzle Diameter	0.4 mm
Filament Diameter	1.75 mm
Print Speed	up to 200 mm/s
Bed Temperature	up to 100 °C
Nozzle Temperature	Up to 280°C
Connectivity	USB
Supported Materials	PLA, PETG, ASA, ABS, Flex
Power Input	100-240 V
Dimensions	380 x 330 mm