Building your MINI+
16 Original Prusa MINI+ semi-assembled
STEP 19 Final tightening
Once the parts are aligned, tighten all screws in this particular order:
First, the M3x12 screw at the top.
Second, the M3x40 screw on the side.
Third, the M3x20 screw on the side.
STEP 20 Haribo time!
Arrange the bears in a similar
pattern as in the picture.
Your package might contain fewer
bears. In such a case, run
immediately to the nearest candy
store! The exact dosage is
absolutely critical!!!
Eat the upper row, leave the others
for the next stages.
I said, leave the others!
To Next Page
Loading...
