Pulsafeeder MicroVision EX - Ethernet (Optional); Programming Your Controller Pulsalink; Setting up Your Controller on Pulsalink

72-900-06 Rev. F
Page 29 of 38
768 = % Post Bleed Timer
512 = 28 day Biocide Timer
256 = Percent Timer
0 = Water Meter Pulse Timer
TMPR Column:
The tamper column will nominally appear as 0. If the unit is tampered
with you will see a 1 in the tamper column. Any other value indicates a
power cycle of the unit.
4.11 Ethernet (Optional)
On a model equipped with Ethernet communications, the MicroVision
EX
controller when
networked via the Ethernet cable and an application appropriate network adapter the user
will able access the controller, download data from the unit and upload programming
changes via our online PulsaLink portal.
4.11.1 Programming your controller PulsaLink
Once the controller’s RJ45 connector has been wired to a reliable Ethernet connection. The
controller has a token which needs to be programmed. After setting the controller token to
a non-zero value (Menu->Communications->Networking->Token) power cycle the
controller to start communicating on PulsaLink. The default token is 000-000-001. See the
PulsaLink user manual for more information.
4.11.2 Setting Up Your Controller on PulsaLink
In order to access your controller online you will need to go to
“https://www.pulsalink.net/login”. Contact your company administrator if you need to be
setup with an account. An administrator needs to grant access to users to each controller.