Pulsafeeder MicroVision EX User Manual

72-900-06 Rev. F
Page 30 of 38
5. FACTORY DEFAULTS
DEFAULTS
SYSTEM CONDUCTIVITY SCALE
0-9,999 S/CM
Set point Type
RISING
Set point
1500 µS/CM
Set point Differential
50 µS/CM
High Alarm
1700 µS/CM
Low Alarm
1300 µS/CM
Limit Timer
00:00 (disabled)
MAKE-UP CONDUCTIVITY SCALE
0-10,000 S/CM
Set point Format
CYCLES
Set point Scale
0-2000 S/CM
Set point Ranges
0-400 / 401-800 / 801-1200 / 1201-1600 / 1601
Set point Range Set points
6.0 / 5.0 / 4.0 / 3.0 / 2.0 Cycles
Set point Differential
40 µS/CM
High Alarm
840 µS/CM
Low Alarm
360 µS/CM
SYSTEM pH SCALE
0-14 pH
Set point Type
Rising
Rising Set point
7.8 pH
Set point Differential
0.2 pH
High Alarm
8.3 pH
Low Alarm
6.3 pH
Limit Timer
01:30
SYSTEM ORP SCALE
-2000-+2000 mV
Set point Type
FALLING/LOW
Set point
400 mV
Set point Differential
50 mV
High Alarm
500 mV
Low Alarm
300 mV
Limit Timer
01:30
4-20mA INPUT
NONE
Units
NONE
4-20mA OUTPUT
0-20 mA
Type
None
LEVEL INPUT
Type
Level
Keep Relay on
FLOW INPUT
Type
Flow
TIMER
Type
DISABLED
TIMER: LIMIT
Run Time
01:30 HH:MM

Pulsafeeder MicroVision EX Specifications

General

Brand	Pulsafeeder
Model	MicroVision EX
Category	Controller
Language	English