USR-TCP232-30x Series User Manual
The password of web console and can be modified. up to 5 characters, can be NULL
This option specifies the maximum number of remote devices/clients (with maximum
of 16 clients), that can be connected to the serial device.
This function is used for the serial device server without any data transmission or
reception for a long time, and the serial server automatically restarts. If the restart
time is set between 0 and 59 seconds, this function does not take effect. Only when
the time is set to be greater than or equal to 60 seconds, the restart function of the
device without data will take effect.
3.2. Configuration software
The parameters are also can be configured by config software. The parameter function is already introduced in
Chapter 3.1. In this chapter, we how to config the parameters via config software.
3.2.1. Search device
Run the config software, if the USR-TCP232-30X Serial Device Server is already connected to the same
gateway as your PC, the device can be accessed via broadcast packets. Users can search all the TCP232-30X
Series device servers on the network and show them on the Serial Device Server List Area of the utility.
Figure 20. Search device
To Next Page
Loading...