7
OPERATION
SWITCHING ON/OFF THE UNIT
Press PWR button (1) to turn on the unit.
When the unit is on. Press and hold for 2
seconds to turn off the unit.
SOUND ADJUSTMENT
Press SEL button (4) shortly to select the
desired adjustment mode. The adjustment
mode will be changed in the following
order:
→BAS‐TRE‐BAL‐FAD‐LOUD‐EQ‐DX‐ST‐VOL
BAS: bass
TRE: treble
BAL: balance
FAD: fader
LOUD:
loudness
EQ: equalization
DX: distance
ST:
STEREO
VOL: volume
By rotating the audio knob (4) clockwise or
counter-clockwise, it is possible to adjust the
desired sound quality.
Press and hold SEL for 2 seconds. You can
choose the area between USA and
EUROPE by rotating the knob 4.
DISPLAY INFORMATION
Press DISP button (2) to show the time.
When you set the hours ok ,then
press "SEL“ button,the minutes number will
be show and turn on VOL to set the
minutes .
LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated
functions on the display .
USB INTERFACE
On the front panel of the unit, there is an
USB interface (6). You can connect an USB
driver through this interface (6).
AUXILIARY INPUT
The unit can be connected to a portable
audio player through the AUX IN jack (7).
RESET FUNCTION
RESET button (8) must be activated with
either a ballpoint pen or thin metal object.
The RESET button is to be activated for the
following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: if press RESET button (8), the unit
can’t work yet, please use a cotton swab
soaked in isopropyl alcohol to clean the
socket on the front panel.
RADIO OPERATION
SWITCHING TO RADIO MODE
Press MODE button (1) to select radio
mode, the radio mode appears in the
display together with the memory band
and frequency.
SELECTING THE FREQUENCY BAND
At radio mode, press BAND button (18)
shortly to select the desired band.
The reception band will change in the
following order:
→FM1→ FM2→ FM3 → AM1(MW1)→AM2(MW2)
SELECTING STATION
Press button (3) or button (16)
shortly to activate automatic seek
function. Press for several seconds until
“MANUAL” appears on the display, the
manual tuning mode is selected. If both
buttons have not been pressed for
several seconds, they will return to seek
tuning mode and “AUTO” appears on
the display.
To Next Page
Loading...
Need help?
General
