Pyronix ENFORCER V11 - Disarming After an Alarm; Using PIN Code or Proximity Tag; Using the Wireless Keyfob

10
ENFORCER V11 EXTENDED USER GUIDE
USING THE WIRELESS KEYFOB
To disarm via a keyfob. Press .
The keyfob LED will ash green indicating that the system has disarmed.
Please note: Disarming with a keyfob will only be allowed if your
engineer has enabled this.
<2 seconds
DISARMING AFTER AN ALARM
USING A PIN CODE OR PROXIMITY TAG
Enter a valid PIN code or present a valid tag to the symbol as
shown.
Enter Your Code
[******]
The alarm symbol will ash indicating there has been an alarm
activation and the keypad will display which zone has activated.
Alarm Silenced
Lounge
Press h to reset the system.
Alarm Panel
Time 10:09 c
USING THE WIRELESS KEYFOB
To disarm via a keyfob. Press .
The keyfob LED will start to ash green indicating that the system has
disarmed.
Rearming the system after an alarm can only be done at the keypad.
Please note: Disarming with a keyfob will only be allowed if your
engineer has enabled this.
<2 seconds