11
ENFORCER V11 EXTENDED USER GUIDE
USING PROXIMITY TAG READERS
ARMING AND DISARMING
If you have a tag reader installed, then it will be possible to arm and disarm the wireless alarm system using a tag
(the same tags can also be used on the readers on the main control panel and keypads).
There are two types of readers that can be used with the wireless alarm system - the internal tag reader and the
external tag reader (used both indoors and outdoors).
Tags for the readers need to be programmed through the ‘Edit Users’ function in the Master Manager Menu. The
internal and external readers can be both assigned to individual areas, this will need to be set up by your engineer.
Disarmed Armed Disarmed Armed
ENTRY CONTROL
The readers may be used for entry control, which means they can operate automatic locks for example as well as
arming and disarming the system. This can be set up by your engineer.
Unlocked
Locked
Unlocked
Locked
External Proximity Reader Instructions
Arming
Present a valid tag to the reader, the green LED will illuminate on the external reader, remove the tag, the door will
unlock, then present the same tag within 10 seconds and the system will arm and the door will lock.
Disarming
Present a valid tag to the reader and then remove it, the status will be shown (the alarm symbol will illuminate
indicating the system is armed on the internal reader and the red LED on the external reader), present the same tag
within 10 seconds again and the system will be disarmed, and the door will unlock.
Access Control/Entry Control
The readers can be used also for opening doors only without the ability to arm and disarm. Please contact your
installer for more information on this feature.
To Next Page
Loading...
Need help?
General
