Pyronix ENFORCER V11 - Sms;Voice Phonebook; Walk Test

23
ENFORCER V11 EXTENDED USER GUIDE
SMS/VOICE PHONEBOOK
SMS PHONEBOOK
SMS Numbers
If SMS or voice messages are activated, there can be up to 10 mobile numbers programmed which can be changed
in this function. If ‘do not use’ is shown on the display of a number, then a telephone number already exists that is
communicating to an Alarm Receiving Centre (this can only be changed by your engineer).
Press b or h to scroll to ‘PHONEBOOK?’.
Press f.
PHONEBOOK?
Press b or d to scroll through the dierent telephone
numbers.
Press f to edit the number.
SMS Numbers?
Enter the mobile number. Press f.
Press [ or ] to enable or disable the number. Press f.
Mobile No. _
WALK TEST
WALK TEST?
The ‘Walk Test’ function allows the testing of all programmed zones on the wireless alarm system.
Press b or h to scroll to ‘WALK TEST?’.
Press f.
WALK TEST?
Select which area to walk test by using the keypad to select a
letter. Press f to walk test the zones allocated in that area or
press the h to walk test a zone individually.
Please note: In order for the walk test to function correctly,
one area must be selected only.
Walk Test Areas
[ABCD]
Walk Test Area
The display will cycle through each of the zones to be walk
tested. Trigger each zone individually and it will be removed
from the cycle. When all zones are triggered the keypad will
display ‘Walk Test Complete’.
Walk Test
Input 01
Walk Test Individual Zones
Press [ or ] to scroll through the dierent zones and press
f to walk test that zone.
Walk Test Input
[01]