Pyronix ENFORCER V11 - Anti-Code and Engineer Restore Facilities; Anti-Code Procedure for Alarm Silence; Engineer Reset Procedure; Fault Indications and Unable to Arm Scenarios

12
ENFORCER V11 EXTENDED USER GUIDE
ANTICODE & ENGINEER RESTORE FACILITIES
Your engineer may have set up the system so that either an ‘Anti-Code’ or ‘Engineer Restore’ is required in order to
fully reset the wireless alarm system
Please note: Your code will still silence the alarm, but it will not reset the system.
ANTICODE
After alarm activation has occurred, enter a valid PIN code,
present a valid tag, or press  on the keyfob to silence the
alarm.
The keypad will display as shown to the right.
Take note of the number, on the screen and call your Alarm
Receiving Centre (ARC).
Press h.
Alarm Silenced
Restore G12298
When the time is displayed, enter the number given to you by
the ARC. ‘Engineer Restore Performed’ will be displayed.
Press h.
Engineer Reset
Performed
ENGINEER RESET
When the time is displayed, enter the Engineer Code.
‘Engineer Reset Performed’ will be displayed.
Press a.
Restore
Required
FAULT INDICATIONS & UNABLE TO ARM
FAULT INDICATIONS
Control Panel
Any faults that occur on the system will be easily recognised by
the ashing ALERT LED.
Alarm Panel
Time 10:09 c
To see what the fault is, enter a valid PIN code, or present a valid
tag, or press  on the keyfob.
Depending on how the system has been programmed by your
engineer, it may be possible to arm the system with a fault, to
do this press f.
Control Panel
Battery Fault
Please note: Any fault may aect the overall performance of your alarm control panel and therefore your
engineer should be contacted for further assistance if any fault is active.