REMOTE SURVEILLANCE QT428 User Manual
58 | Page
Setting up MYQ-SEE DDNS:
NOTE: Before you setup DDNS you must first set up Port Forwarding as directed in Section 7.3 PORT
FORWARDING. Once you have enabled Port Forwarding, you can configure your DDNS information by
following these steps:
a. Using a computer that is connected to the same network as your Q-See DVR, use your IE Browser to go to
http://myq-see.com.
b. Click on the New User? Link at the bottom of the page (http://myq-see.com/reg.asp).
c. Complete the registration process by following the on-screen directions and click the [Submit] button at the
bottom of your screen (Fig 7-8).
Fig 7-8 Registration
To Next Page
Loading...
