Q-See QT428 User Manual

REMOTE SURVEILLANCE QT428 User Manual
67 | Page
Click on Custom Level
Pic 12
On “Reset to” pull down menu, select “LOW” then
click on “RESET” button.
Click ‘Yes’ when asked: ‘Are you sure you want to
change the setting for this zone?’ Click OK. Click
Apply. Click OK. Close Internet Explorer.
Pic 13
If you get a error message that says the program cannot load because the publisher is unknown or the program is
unsigned, go to internet explorer, tools, internet options (refer to Pic 9), then go to the “Advanced” tab (RED box in Pic
14), this will open the window in Pic 15, scroll down to “Security”, and select the options to “Allow software to run or
install even if the signature is invalid”, and “Allow Active Content to Run Files on My Computer” (RED box in Pic 15).
Pic 14 Pic 15

Q-See QT428 Specifications

General

Brand	Q-See
Model	QT428
Category	DVR
Language	English