QNAP TS-h1290FX - Quts Hero Installation

a. Connect the USB cable to the USB Type-C port on the expansion unit.
b. Connect the USB cable to a USB 3.2 Gen 1 Type-A port on the NAS.
2. Power on the expansion units.
3. Verify that the expansion units are recognized by the NAS.
a. Log on to QuTS hero as administrator.
b. Go to Main Menu > Storage & Snapshots > Overview > System .
c. Verify that the expansion units are listed.
QuTS hero Installation
The TS-h1290FX uses the QNAP QuTS hero operating system. You can install QuTS hero using any of the
following methods.
TS-h1290FX User Guide
Installation and Conguration 31