Quadra-Fire SANTA FE - Section 4: Replacement Parts; A. Convection Blower Replacement; B. Combustion Blower Replacement

R
December 1, 2011
Page17
Santa Fe NZ Pellet Stove
7068-114B
NOTE:Anywarrantyonthereoritspartsisvoidifdamage
is caused during maintenance, or if maintenance is done
incorrectly.
Replacement Parts
4
A. Convection Blower Replacement
1. Turndownthethermostat,letappliancecompletelycool
andthenunplugappliancebeforeservicing.
2. TheConvection Blower is located on the oor at the
rearoftheappliance.
3. Removetherightsidecurtainbyloosening7/16”nutin
thbackandliftoffoftheappliance.Whenre-installing
excurtaintore-attach.Figure 17.1.
4. Cutthetiewireholdingthewirestogetherandthendis-
connecttheredandblackwires.
5. Remove wingnut and hold-down bracket and then
removeblower.
6. Re-installinreverseorder.
7. Attachnewtiewiretoholdwirestogether.
Back of Side Curtain
Slot
Ribs on Curtain Slide into
Slots at Top and Bottom
Figure 17.1
Figure 17.2
B. Combustion Blower Replacement
1. Turndownthethermostat,letappliancecompletelycool
andthenunplugappliancebeforeservicing.
2. Removebothsidecurtains.Figure 17.1. .
3. Disconnecttheredandblackwires from the whiteand
bluewiresfromtheexhaustblower.
4. Thereisaremovableplateontheexhaustblower.Using
a1/4”socketorshortstandardscrewdriverloosenthe6
screwsinthekeyholeshapedholesandrotatetheplate.
Figure 17.4.
5. Removetheexhaustblowerandgasket.
6. Re-installinreverseorder.
Side curtains slip under the 6 nuts
identified by the square marking.
Remove the circled screws to
remove the upper and lower rear
screens.
Figure 17.3
Figure 17.4