Foot Platform Depth Adjustment
You can adjust the depth of the foot platform.
To adjust the foot platform depth:
1. Remove the hardware from the foot platform bracket. See fi gure 14.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the hardware into the foot platform bracket and tighten.
Power Elevating Seat (Optional)
If your power chair is equipped with a power elevating seat, you can change
the seat height either through the controller or through a toggle switch
mounted to one of the armrests.
To change the seat height through toggle switch:
1. Press forward on the toggle switch to raise the seat. See fi gure 15.
2. Pull back on the toggle switch to lower the seat.
WARNING! Do not allow the motor to run more than a few seconds
after the mechanism reaches the top or bottom limit.
NOTE: For more information on operating the power elevating seat
through the controller, contact your Quantum Rehab Provider.
WARNING! The power elevating seat option is intended for use on a
level surface only. Never raise the seat from its lowest position on an
inclined surface. Failure to heed this warning can result in the power
chair tipping over.
WARNING! Never raise the seat from its lowest position when operating
your power chair on bumpy or uneven surfaces. Failure to heed this
warning can result in the power chair tipping over.
WARNING! Never raise the power elevating seat while your power chair
is in the freewheel mode.
WARNING! Always fasten the positioning belt when operating the
power elevating seat.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the screw. See fi gure 14.
2. Turn the screw to raise or lower the front of the foot platform.
To Next Page
Loading...
Need help?
General
