GL100 User manual
4.4.9. Set the parameters of white call list
Step_5
Step_6
Step_7
Step_3
Step_2
Step_4
Step_1
Step_1: Select “Enable This Function”, after that the parameters of GTWLT can be changed and
the "Send" button is enabled.
Step_2: When “Enable This Function” is selected, the command message which shall be sent to
GL100 will be generated based on input and displayed here. Please note this command
message can also be sent to GL100 through SMS or GPRS.
Step_3: It is recommended to read the parameters from GL100 and edit based on them.
Step_4: Set call filter enable or disable in white call list function. Please refer to “GL100 @Track
Air Interface Protocol” for detail.
Step_5: Set the white call list index from start to end which you want to edit. Please refer to the
“GL100 @Track Air Interface Protocol” for detail.
Step_6: Set the number list of white call list function. Please refer to “GL100 @Track Air
Interface Protocol” for detail.
Step_7: Click the “Send” button; download the parameters of GTWLT to GL100.
TRACGL100UM002 - 25 -
To Next Page
Loading...
